Sinoma (Yichang) Energy Conservation New Material Co., Ltd.
Respect, Sincerity and Integrity, Harmony and Efficiency
Add to Cart
Non Asbestos High Strength Fiber cement cladding Board
Product Name
Light compressed board: average density is 1.4g/cm3, thickness from 4-16mm
Middle density board:average density is 1.3g/cm3, thickness from 4-20mm
High density board:average density is above 1.6g/cm3, thickness from 4-30mm
standard size is 1220*2440mm, max size is 1220*4880mm, Other special size also can be made based on your demend.
The Color is also customized, you can chose your color by your needs.
Installation
Tools:
No special tools are required. The products can be used with normal nails, fastened by normal or self-drilling screws and cut by an electric power saw with a diamond blade.
Fixing:
Sinoma Board can be fixed to both timber (minimum size 1.5 x 3 inches) or steel frames (at least 0.55 mm thickness). The board must be supported at the edge at intermediate positions with centers not exceeding 600 mm. Screws must be located more than 12 mm from edges and 50 mm from board corners.
Fastener:
Fasteners can be both nails and screws. It can be nailed directly to timber supports with round wire nails. For metal screws, the size and length of the screw depends on the thickness of the board and the gauge of framing.
Jointing:
Since fiber-cement board is subject to slight dimensional changes, a butt joint can be used in dry partitioning areas or where an exposed joint appearance is acceptable. For better water protection, either flexible acrylic or polyurethane based sealant can be used to seal gaps of 3-5mm.